HDPE Plastic 5 Liter Bottle Extrusion Blow Molding Machinery Line
Introduction
This model is fixed open-closing and accumulator die head series
which adopts double drawbar clamping mechanism, mold clamping by
oil cylinder pressure directly, It suits for making 1-5L chemical
packing drums, medium size toys, auto parts pipes, water container,
toolcase, sprayer and so on. Technical characteristics: Hydraulic
servo system control, quick action response, energy saving.
Machine Features
1. Stable performance with advanced PLC.
2. Conveying preforms automatically with conveyor.
3. Strong penetrability and good and swift distribution of the heat
by letting the bottles rotate by itself and revolute in the rails
simultaneously in the infrared preheater.
4. High adjustability to enable the preheater to preheat preforms
in shapes by adjusting the light tube and the length of the
reflecting board in the preheating area, and eternal temperature in
the preheater with an automatic thermostatic apparatus.
5. High safeties with security automatic-locking apparatus in each
mechanical action, which will make the procedures turn into a state
of safety in case of a breakdown in certain procedure.
6. No contamination and low noise with the air cylinder to drive
the action instead of the oil pump.
7. Satisfaction with different atmospheric pressure for blowing and
mechanical action by dividing the blowing and action into three
parts in the air pressure diagram of the machine.
8. Strong clamping force with high pressure and double crank links
to lock the mold.
9. Two ways of operating: automatic and manual.
10. Safe, reliable, and unique design of the position of valve to
make the air pressure diagram of the machine easier to understand.
11. Low cost, high efficiency, easy operation, easy maintenance,
etc, with automatic technological process.
12. Contamination is avoided for the bottle body.
13. Ideal effect of the chilling with the chilling system.
14. Easy installation and starting.
15. Low rejection rate: less than 0.2 percent.
Parameter
SPECIFICATIONS & TECHNICAL DATA |
| Screw Diameter | mm | 80 |
Plasticizing Capacity | Kg/hour | 110 |
Temperature Control Zone | No. | 5 |
| Single Head Max Die Diameter | mm | 230 |
Double Head Central Distance | mm | 230 |
Four Head Central Distance | mm | 120 |
Six Head Central Distance | mm | 85 |
| Clamping Force | KN | 110 |
Platen Size | mm | 580x420 |
Opening Distance | mm | 150~450 |
Moving Distance | mm | 720 |
Max Mould Size | mm | 630x385 |
| Extrusion Motor Power | KW | 30 |
Pump Motor Power | KW | 15 |
Machine Total Power | KW | 72 |
Average Power Consumption | KW | 42 |
